How to apply the Screen Protector Film
This explains how to apply the Silicon Film.
Also, the manual is downloadable as a PDF file from below link.
⇒The Silicon Film PDF
Before applying the film, check the place where it will be attached.
*Please take care that the film is not upside-down.
Use a soft cloth, wipe the whole LCD screen to remove dirt and dust and clean it.
*Using strong force to wipe the LCD screen may cause damage. Please wipe gently and carefully.
Use the adhesive side of Scotch tape or similar to remove any remaining dust or dirt from the LCD screen.
Use the [ A:Dust Removal Sheet ] if included with the product.
*This step is most effective if it is done immediately before attaching the film.
Peel off the film completely.
*The four corners are slightly detached to make the film easier to peel off.
*Do your best to ensure that your fingers do not touch the adhesive side of the film as this may leave fingerprint marks behind.
Gently place the film from the center onto the place where you want to affix the back film.
*If the film slips away from your intended location, peel it off and affix it again.
The adhesive of this film is too strong so rather than peeling it off in one go, remove it gently and slowly off your device.
Affix the film working outward from the center so as to push away any air bubbles that are trapped between the film and the back of your device.
Use the [Squeegee] if included with the product.
Finally, peel off the protective film on the surface of the silicon film.
If included with the product, use the [removal sticker] by attaching it to any one of the four corners.
If the back film is divided into parts, attach the remaining films to the top and bottom portion respectively.
Please peel off the protective film on the surface as a final step.
Is completed.
*The adhesive surface of the silicon film features a special coating that prevents the formation of air bubbles.
Although a noticeable grid pattern may remain, it should then gradually disappear and become almost invisible after 4 to 5 days.
Use a soft cloth and gently clean the camera lens.
Peel off one transparent film for camera lense from the backing film and leave the film half peeled off.
Apply adhesive tape (Ex, Scotch tape) to about half of the film for camera lense, and peel it off the backing film.
Use the [ B:Camera Lens Auxiliary sheet ] if included with the product.*Please note: If you put the auxiliary sheet on the film entirely not partially, it may become difficult to apply.
Place the film on the camera lense, which has now been detached from the backing film.
Once you have decided on its position, use one finger to place the film on the camera lens, apply it firmly to the camera lens and then you are ready to go.